MIL-PRF-39019F
DEPARTMENT OF DEFENSE SPECIFICATIONS
(See supplement 1 for list of specification sheets.)
DEPARTMENT OF DEFENSE STANDARDS
-
Test Methods for Electronic and Electrical Component Parts
-
Marking of Electrical and Electronic Parts.
(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or
https://assist.daps.dla.mil/ or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D,
Philadelphia, PA 19111-5094).
2.3 Non-Government publications. The following documents form a part of this document to the extent specified
herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract (see
6.2).
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
- Calibration Laboratories and Measuring and Test Equipment - General Requirements.
INTERNATIONAL ORGANIZATION FOR STANDARDS (ISO)
-
Measurement management systems - Requirements for measurement processes
and measuring equipment.
(A Copy of this document is available from https://www.ansi.org/ or the American National Standards Institute (ANSI),
11 West 42nd Street, New York, NY 10036-8002).
INSTITUTE OF ELECTRICAL AND ELECTRONIC ENGINEERS, INC. (IEEE)
-
Graphic Symbols for Electrical and Electronic Diagrams.
(A Copy of this document is available from https://www.ieee.org or from the Institute of Electrical and Electronic
Engineers (IEEE), IEEE Operations Center, 445 Hoes Lane, P. O. Box 1331, Piscataway, NJ 08855-1331, Phone: +1
732 981 0060, Fax: +1 732 981 1721.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between the
text of this document and the references cited herein (except for related specification sheets) the text of this
document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless
a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in accordance with the
applicable specification sheet. In the event of any conflict between the requirements of this specification and the
specification sheet, the latter shall govern.
3.2 Qualification. Circuit breakers furnished under this specification shall be products that are authorized by the
qualifying activity for listing on the applicable qualified products list before contract award (see 4.5 and 6.3).
3.3 Material. Material shall be used which will enable the circuit breakers to conform to the performance
requirements of this specification. Acceptance or approval of any constituent material shall not be construed as a
guaranty of the acceptance of the finished product.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business